|
|
Quellcode |
1 |
sudo fdisk -l |

|
|
Quellcode |
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 |
Platte /dev/sda: 320.1 GByte, 320072933376 Byte 255 Köpfe, 63 Sektoren/Spuren, 38913 Zylinder Einheiten = Zylinder von 16065 × 512 = 8225280 Bytes Disk identifier: 0x00079010 Gerät boot. Anfang Ende Blöcke Id System /dev/sda1 1 27746 222869713+ c W95 FAT32 (LBA) /dev/sda3 * 27747 38453 86003977+ 83 Linux /dev/sda4 38454 38913 3694950 82 Linux Swap / Solaris Platte /dev/sdb: 2251919.8 GByte, 2251919848333312 Byte 255 Köpfe, 63 Sektoren/Spuren, 273780327 Zylinder Einheiten = Zylinder von 16065 × 512 = 8225280 Bytes Disk identifier: 0x9d469d46 Festplatte /dev/sdb enthält keine gültige Partitionstabelle |
durchführen und anschließend nach der Installation im Terminal ein
Zitat
sudo apt-get install testdisk
absetzen und warten was der Befehl ans Tageslicht bringt.
Zitat
sudo testdisk /dev/sdb
|
|
Quellcode |
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 |
TestDisk 6.11, Data Recovery Utility, April 2009 Christophe GRENIER <grenier@cgsecurity.org> http://www.cgsecurity.org Disk /dev/sdb - 2251 TB / 2048 TiB - ATA WT7160426A$ $ $ Please select the partition table type, press Enter when done. [Intel ] Intel/PC partition [EFI GPT] EFI GPT partition map (Mac i386, some x86_64...) [Mac ] Apple partition map [None ] Non partitioned media [Sun ] Sun Solaris partition [XBox ] XBox partition [Return ] Return to disk selection Note: Do NOT select 'None' for media with only a single partition. It's very rare for a drive to be 'Non-partitioned'. |
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Fraenk« (30. Juli 2010, 14:42)



|
|
Quellcode |
1 |
Error mounting: mount exited with exit code 32: mount: /dev/sdb2: can't read superblock |
Burning Board, entwickelt von WoltLab GmbH.
UbuntuFreunde von Easyy-S und basslord seit 06.12.06
Ubuntufreunde.de runs on ubuntu 10.04





